牧野機床出現以下問題，哪個大神幫忙解決

朱一濱

牧野機床出現以下問題，哪個大神幫忙解決。多謝了！

* B! @; x' R! S! O; Q5 f, H& B機床問題：
5 h! j! m5 x) E$ ]& k. f+ t" a
( Y# a: G/ e, t/ \5 m* v4 k1、SPNDL SPEED COMMAND IS NOT SET WHEN START SW，WAS PRESSED
# @6 B4 N+ l0 k7 r, Q
COMMAND S—CODE AFTER RESET ALARM

2、NOZZLE CLANT THERMAL RELAY IS TRIPPED
) q" I( l+ x2 T0 w9 ^& E
( G% c2 F2 T& U) S) E0 Y! d) TDI SIGNAL TH2... WENT ON
5 S. v2 Q6 b0 l9 }8 }) u+ ]8 H
CHECK THERMAL RELAY AND THE BREAKER
. _( q8 J/ h$ x+ y" D
3、NC ALAMRE IS BEING GENERATED

0 `: h  J0 E# u0 _% JBMI SIGNAL AL....IS ON
4 Q. Y5 t1 B4 K2 A4 y+ k. }
CHECK FAULTY DEVICE
# a) [, M+ Y9 H, O5 N, B
4、TOOL CLAMP SIGNAL TOOK OFF DURING SPINDLE CW ROTATION DI SIGNAL LS00..IS OFF

CHECK THE CONDITION OF LIMIT SWITCH，SILENOID AND ETC

5、MAN. TOOL UNCLAMP & CLAMP CANNOT PERFORM AT AUTO MODE

8 y& U! d' y% J4 M7 Z- b8 z! y! ESELECT CORRECT CODE