|
|
牧野機床出現以下問題，哪個大神幫忙解決。多謝了！+ _* n" S, Z& C
3 m$ c* t& ^9 _7 q# F* d* Y g機床問題：
+ b- o1 s' M( N; j! q7 _& j
2 Y1 u; i5 L6 I: G1、SPNDL SPEED COMMAND IS NOT SET WHEN START SW，WAS PRESSED
2 c' f3 b l1 J
: I& n7 c( y% C% yCOMMAND S—CODE AFTER RESET ALARM# x+ `. B. ^- N0 u# K9 ]
( o' @. {' I" |, {3 \, q2、NOZZLE CLANT THERMAL RELAY IS TRIPPED
/ |+ j4 ?7 p+ _. X: W1 ?
/ w) n, b1 o2 s- O) pDI SIGNAL TH2... WENT ON) h. T4 Z F* V \+ b: ]) x
( G2 q7 S# r) N# ? e: K* YCHECK THERMAL RELAY AND THE BREAKER
3 o( k2 z' o4 r/ Z4 E. T4 e# S7 Z$ \7 o
3、NC ALAMRE IS BEING GENERATED
$ r" S; h7 _4 z! X
* T4 Y4 S0 w9 w% F: d% O4 ~BMI SIGNAL AL....IS ON
9 [) C6 y( a5 e: V# \
) {9 V1 L) z3 v8 ]8 L1 {5 L( nCHECK FAULTY DEVICE1 n. p1 V A1 c* M' w
4 `) z. V7 o) R4 L R
4、TOOL CLAMP SIGNAL TOOK OFF DURING SPINDLE CW ROTATION DI SIGNAL LS00..IS OFF
6 M( b6 M2 A) _# V. m2 d1 L$ T: G% b- e
CHECK THE CONDITION OF LIMIT SWITCH，SILENOID AND ETC
3 w: R2 a7 Z4 a/ C, W; k8 v4 D& f9 C2 `
5、MAN. TOOL UNCLAMP & CLAMP CANNOT PERFORM AT AUTO MODE
/ O1 E/ U( `. x' Z5 g) i
7 r2 h7 R! E T* wSELECT CORRECT CODE8 v$ d* V* h2 N3 [4 q$ U& V5 W
|
評分
-
查看全部評分
|
發表于 2015-7-30 16:52:32
QQ好友和群
收藏
淘帖
問題專業，描述清楚
伸手黨/灌水/看不懂